| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| How to removed sanding dust from pores http://www-.luthiersforum.com/forum/viewtopic.php?f=10101&t=40331 |
Page 1 of 1 |
| Author: | hummingbird [ Sun May 12, 2013 10:20 am ] |
| Post subject: | How to removed sanding dust from pores |
After sanding down my grain filler, I thouroughly vacuumed off the white dust then wiped it down with a microfiber cloth. However, there were still some pores white specs of white powder in them. I was hoping the specs would absorb the following coats of vinyl sealer and nitro but they did not. Now I have little white specs in various places including the headstock. How can I prevent this from happening in the future. |
|
| Author: | bluescreek [ Sun May 12, 2013 10:41 am ] |
| Post subject: | Re: How to removed sanding dust from pores |
I use compressed air and blow it out the best I can , then wipe down with naphtha. |
|
| Author: | John Sonksen [ Sun May 12, 2013 10:50 am ] |
| Post subject: | Re: How to removed sanding dust from pores |
bluescreek wrote: I use compressed air and blow it out the best I can , then wipe down with naphtha. I think wiping it down with naphtha is the key |
|
| Author: | Stuart Gort [ Sun May 12, 2013 11:06 am ] |
| Post subject: | Re: How to removed sanding dust from pores |
bluescreek wrote: I use compressed air and blow it out the best I can , then wipe down with naphtha. ditto....make that a habit. |
|
| Author: | Joe Beaver [ Sun May 12, 2013 8:45 pm ] |
| Post subject: | Re: How to removed sanding dust from pores |
Air. If you don't have a compressor the cans of air will work |
|
| Author: | hummingbird [ Mon May 13, 2013 4:03 am ] |
| Post subject: | Re: How to removed sanding dust from pores |
Looks like I have my answer. Thanks all. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|